3D Printing
Print the four parts from hardware/enclosure/stl/ before assembly. No supports required on any part.
Print settings
Material: PETG or PLA+
Layer height: 0.2 mm
Walls: 3
Parts
| Part | File | Print notes |
|---|---|---|
| Bottom tray | deck_bottom_v14.stl | Flat on bed, no supports |
| Top shell | deck_top_v14.stl | Face-down, no supports |
| Corner spacers ×4 | corner_spacers_x4_v14.stl | 100% infill recommended |
| Desk stand (optional) | deck_stand_v14.stl | Upright, 15–20% infill |
Corner spacers
Print the corner spacers at 100% infill. They replace the factory standoff at each deck corner and carry the M2×25 case screw through the stack.
Rev E enclosure
v14 matches the Rev E carrier: wider key pitch, eight LED wall windows, a Ø3 ALS light-pipe in the face plate, and a Qwiic opening next to USB-C. Do not mix v13 prints with a Rev E board (or the other way around).
OpenSCAD sources live in hardware/enclosure/. When you're ready to assemble, continue to the Assembly Guide.