Skip to content

Build It

This is the path from an empty desk to a working deck. Order the modules first. Print and fab while they ship. Hands-on assembly is about an hour once the parts are in.

  • 1 · Order

    Six ScreenKey modules (longest lead time), a Rev E PCB from the Gerbers, M2 screws, inserts, rubber feet.

    Parts list

  • 2 · Print

    Four STLs, no supports, PETG or PLA+. Start these as soon as you place the PCB order.

    3D printing

  • 3 · Assemble

    Heat-set inserts, screw modules to the carrier, plug the in-box cables, four corner screws.

    Assembly guide

  • 4 · Flash

    USB-C into the board. Arduino IDE or the companion app. After this it shows up as a keyboard.

    Flashing

Sending your own Gerbers to JLCPCB? Walk through the fab checklist before you upload, then again at bring-up.